loading

The RT2910A is a PWM inverting converter integrates HV (High Voltage) Switch Driver. The HV switch driver protects loads from high voltage transients. It regulates the output during an over-voltage event, by controlling the Gate of an external N-MOSFET. The output is limited to a safe value thereby allowing the loads to continue functioning. The RT2910A also monitors the voltage drop between the VHV and SNS pins to protect against over-current faults. An internal amplifier limits the current sense voltage to 50mV. If the fault condition persists, the MOSFET is turned off. After a certain cooling off period, the gate is allowed to go up and turn on the MOSFET again. Moreover, the HV switch driver also can support back to back FETs application to prevent reverse leakage current from output.

The high-efficiency PWM inverting converter allows designers to implement compact, low noise, negative output DC-DC converters. This device operates from +4V to +7V input voltage and generates -500mV to -12.5V output. To minimize switching noise, it features a current-mode, constant frequency PWM control scheme. The operating frequency can be set from 300kHz to 800kHz through a resistor.

Applications

  • Ga-N MOSFET Bias
  • Positive to Negative Conversion
  • Industrial and Telecom Power Supplies
  • Distributed Power System
Key Spec.
RT2910A
Status Active
Vin (min) (V) 4
Vin (max) (V) 7
Channel Number 1
Features Adjustable Current Limit;Adjustable Frequency;Current Mode Control;OCP;OVP;Power Good
Package Type WQFN5x5-24
Features
  • HV Switch Driver
    ► Adjustable Output Clamp Voltage
    ► Over-Current Protection
    ► Wide Operation Range : 5V to 60V
    ► Reverse Input Protection to −60V
    ► Adjustable Fault Timer
    ► Support N-MOSFET
  • Inverting PWM Converter
    ► -12.5V to -0.5V Output
    ► Integrate High-Side P-MOSFET
    ► 300kHz to 800kHz Switching Frequency
    ► Current-Mode PWM Control
    ► Internal Soft-Start
    ► Power Ok Indicator
TOP